Accurate Technology Digi-Stop Especificaciones descargar pdf (Pagina 7)

Accurate Technology DigiStop Page 7 of 16

SECTION 2 INSTALLATION

Mounting the Fence Assembly

1. Align the Fence Assembly adjacent to the saw

(Scale is to the rear of the fence).

2. Mark a line on the table top, along the front edge of

the Fence.

3. Remove the Fence assembly and mark a second line 7/8 inch (22mm)

behind the first line (this is the centerline of the Fence).

4. Drill mounting holes (at least 2) into the tabletop along the centerline of the

Fence.

5. Insert the supplied 10mm bolts

through the table from the top.

Install the supplied hex nuts onto

the bolts 1 or 2 threads deep at this

time.

6. Slide the Fence, end first, back into

place capturing the bolt heads in the

bottom T-slot of the Fence

Assembly. After the Fence is in

place and aligned to the saw,

tighten all nuts.

Install Stop Assembly

1. Carefully slide the encoder onto the Scale.

2. Loosen the locking knob and slide the Stop assembly into the fence

extrusion.

3. Position the encoder and Stop together and slide the encoder under the

Guide Clip so the post on the encoder is

captured in the slot of the Guide Clip, as shown

below

4. Attach the readout to the aluminum block on the

stop using the enclosed strips of Velcro. Plug

the encoder into the readout .

5. Move the stop assembly left to right and note if

the readings increase or decrease. Depending

upon the installation (left or right infeed), it may

be necessary to reverse the reading direction.

See Section 3: Reverse Readings

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Sin comentarios

Accurate Technology Digi-Stop Especificaciones Pagina 7