Accurate Technology Digi-Stop Especificaciones descargar pdf (Pagina 15)

Accurate Technology DigiStop Page 15 of 16

Programming Parameters

The Digi-Stop readout programming parameters are listed below.

Values in [ ] are the available range of values that can be entered for that

parameter. Factory defaults are shown in Bold Red.

Pr 1 – Datum Key [0 to + 999.999in] or [0 to +9999.99mm]

The programmed value that will be recalled whenever the DATUM key is

pressed during normal operation. Default = 0.00

Pr 2 – Reverse Readings [0 or 1]

This parameter controls the direction of travel (positive vs. negative) when the

stop is moved. Default = 0

Pr 3 – Key Lockout [0 or 1]

This parameter controls the operation of the +, - and DATUM keys.

If enabled, (set to 1), these keys will not function and the LOCK symbol will

appear on the display. This prevents accidental changes when pressing these

keys during normal operation. Default = 0

Pr 4 – Readout Resolution [1, 2, 3 ]

This parameter sets the number of places to the right of the decimal point on

the readout. Default = 2

A value of 1 – Low - will display x.x.

A value of 2 – Normal -will display x.xx

A value of 3 – High - will display x.xxx

Frequently Asked Questions

What F/W (Firmware) version do I have?

The readout will display the firmware version on power up.

What does no Enc mean?

If the encoder cable is unplugged from the readout , no Enc will appear

on the display. To clear: Be sure the encoder is on the scale and

plugged into the readout.

The battery clips seem to be very loose. Is this normal?

Yes. DO NOT attempt to bend these clips or wedge anything between

them and the case. These clips are designed to expand when the two

case halves are screwed together.

The readings are “backwards”?

You can change reading direction of the Digi-Stop by changing the

value of Programming Parameter Pr 2.

What does b FAIL mean?

When the readout displays this message it means the battery voltage

has dropped to a level where reliable operation is no longer possible.

Install new batteries to clear this message.

What does P FAIL mean?

When the readout displays this message it means the battery voltage

has dropped to a level where reliable programming is not possible.

Install new batteries to clear this message.

1 2 ... 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

Accurate Technology Digi-Stop Especificaciones Pagina 15

Comentarios a estos manuales