Accurate Technology Digi-Stop Especificaciones descargar pdf (Pagina 13)

Accurate Technology DigiStop Page 13 of 16

if one was entered, and may be changed by using the + or - keys to provide a

different offset. Moving the stop in either direction will display the distance

moved from the initial INC starting point (plus any offset). To complete another

incremental measurement from the new position, momentarily press the UNITS

key. The readout will again change to 0 (or the previously programmed offset).

To return to the ABS mode, press and hold the UNITS key for approximately 3

seconds.

NOTES: When the readout is in incremental measuring mode the UNITS key no

longer functions to change the measurement units displayed.

The absolute position of the Digi-Stop is not lost when using the incremental

mode. When the readout is switched back to the absolute mode the readout

reflests the current stop position relative to your original calibrated absolute

setting.

Circuit Board Jumpers

The Digi-Stop readout has several user configurable jumpers consisting of

three pins and a ‘shorting block or jumper’.

The center of these three pins is ‘Common’. One end pin is labeled A and the

other end pin is labeled B.

JP1 FACTORY USE ONLY

JP2 Programming Lockout

Position A, Front Panel Programming is ENABLED

Position B, Front Panel Programming is DISABLED

JP1

JP2

1 2 ... 8 9 10 11 12 13 14 15 16

Sin comentarios

Accurate Technology Digi-Stop Especificaciones Pagina 13