Accurate Technology ProScale Manual de usuario descargar pdf (Pagina 32)

Accurate Technology ProScale Page 32 of 48

Pr22 – Backlight ON time [0, 1, 2, 3 or 4]

The ON time of the LCD backlighting (24VDC Displays only).

0 = always off.

1 = 3 seconds.

2 = 7 seconds.

3 = 15 seconds.

4 = always on.

NOTE: Backlighting is activated when a key is pressed.

Pr 23 Future Use [1]

DO NOT CHANGE

Pr 24 Display RF Address [0 to 63]

This parameter is used to set the address of the Display.

0= (RF off)

Pr 25 RF System ID [0 to 31]

This parameter is used to set the ID of the Display system (or

family).

Pr 26 Noise Suppresion [0..7]

This setting helps filter error causing interference caused by stray

electrical noise when the Display is mounted on or around a

machine.

0 = Minimum filtering

7 = Maximum filtering

Pr 27 Accuracy Compensation Enable * [0, 1]

This setting enables the ProScale Display measurement

compensation feature.

0 = Compensation Off

1 = Compensation On

Pr 28 Compensation Multiple * [5]

This value is the length of the measurement standards used for

Accuracy Compensation Calibration.

The default is 5 inches. If some other multiple (length) is used,

change this value to match the multiple (length). i.e. 6”.

* Pr27 and Pr28 are operational ONLY on Displays with Firmware versions

ending in “C”

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

Sin comentarios

Accurate Technology ProScale Manual de usuario Pagina 32