Accurate Technology ProScale Manual de instalación Pagina 13

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 48
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 12
Manual Part # 800-1402-001 Rev E Page 13 of 48
The LCD
The above figure illustrates all the segments available on the LCD
Pressing and holding the ON/OFF and UNITS key for 10 seconds with
power OFF will perform a full segment LCD test, display the current
firmware version, AND RESET ALL PROGRAMMING PARAMETERS TO
FACTORY DEFAULT VALUES.
NOTE: The DRO may also be defaulted to original factory settings by removing
the battery and then pressing and holding the UNITS key while re-inserting
battery. *
* Internal jumper JP3 must be set to the Program Enable position to allow
the DRO to be reset to factory defaults as described above.
Vista de pagina 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Comentarios a estos manuales

Sin comentarios